2011 Land Rover Range Rover Sport 3.0L Diesel · PL11 MEN

A history of significant modifications to the exhaust system and intermittent suspension failures defines the mechanical record of this vehicle. While the test on 8 June 2023 resulted in a pass with no defects, the preceding failure on 1 June 2023 revealed a particulate filter that had been cut open and welded, alongside a leaking offside suspension levelling valve. This follows an earlier failure in 2018 involving excessive corrosion of the brake pipes from front to rear and a worn track rod end, suggesting a pattern where critical structural and emission components have required corrective action to maintain roadworthiness. The recorded mileage of 94,542 miles is typical for a fifteen year old vehicle, averaging approximately 6,303 miles per year. This steady rate of accumulation suggests the vehicle has been used consistently rather than sitting for extended periods. However, the historical failure regarding brake pipe corrosion indicates that the vehicle has been exposed to environmental conditions that accelerate oxidation, which is a critical point of inspection for the remaining chassis and brake line integrity. Attention should be paid to the suspension and drivetrain components that were flagged as worn in 2023. Specifically, the front anti-roll bar bushes and the nearside rear upper suspension arm bush were noted as having play. During a test drive, listen for knocks or clunks when traversing uneven surfaces or during low-speed maneuvers. Furthermore, the recorded play in the rear prop shaft center support bearing should be monitored; a vibration felt through the chassis or floorpan during acceleration is a primary symptom of a failing center bearing. The previous failure of the offside suspension levelling valve necessitates a close inspection of the vehicle's ride height stability. Ensure the vehicle levels itself correctly and does not lean to one side after being parked or during transit. Given the recorded modification to the diesel particulate filter, a professional inspection of the exhaust system is required to ensure the weld is secure and that the modification does not lead to excessive emissions. Finally, verify the current condition of the brake pipes to ensure the 2018 corrosion issues have been fully addressed across the entire length of the vehicle.