2008 Vauxhall Antara E Cdti 2.0L Diesel · RHZ 4658

The Vauxhall Antara’s most recent MOT test on 30 May 2022—just 4 years and 2 months ago—confirmed a pass with no recorded defects, though the preceding tests in April 2021 and December 2019 both resulted in failures despite no specific faults being logged. This inconsistency suggests either a pattern of last-minute pre-test repairs or an incomplete record, as the failures lack diagnostic detail. The vehicle’s current roadworthiness cannot be confidently assessed beyond the last pass, but the lack of advisories or repeated issues in the most recent test implies no overt mechanical degradation was detected at that stage. However, the abrupt failures in 2021 and 2019—without explanation—raise caution, particularly if they coincided with critical components nearing their typical lifespan. The recorded mileage of 143,562 miles over 18 years aligns with average usage for this age, averaging around 8,000 miles annually. There are notable gaps in the MOT history: a 13-month hiatus between the 2019 February failure and the December 2019 test, followed by another 23-month gap until April 2021. The jump from 126,395 miles in February 2019 to 136,172 miles by December suggests roughly 9,777 miles accumulated in under a year, which is within reasonable bounds but implies accelerated wear on suspension bushes, coil springs, and drivetrain components if not maintained. The absence of intermediate tests makes it impossible to verify whether critical issues were addressed or if the vehicle was driven unsafely during these periods. Given the sparse MOT record, a buyer should prioritise an independent inspection of high-wear areas likely to have been overlooked. Focus on the suspension—particularly rear coil springs and bushes—for excessive play or corrosion, as these often fail silently. The braking system warrants scrutiny: the repeated failures without defects could indicate binding rear calipers, warped discs, or deteriorated master cylinder seals, all of which degrade gradually. Examine the subframe and sills for structural rust, as CDTI engines are prone to corrosion in wheel arches and underbody panels. Finally, check the exhaust system for leaks or cracked pipes, as emissions-related failures are common in older diesel models, even if not explicitly recorded. The lack of advisories in recent tests does not guarantee these areas are sound.