2020 Skoda Scala 1.5L Petrol · SA20 FYB

The most recent MOT test on 12 November 2025 resulted in a pass with no defects recorded. Reviewing the history back to June 2023, the vehicle has consistently passed every inspection without a single advisory or failure. This indicates a highly stable maintenance trend and suggests a vehicle that has been kept in excellent mechanical condition or has been subject to proactive preventative maintenance by the previous owner. With a recorded mileage of 51,686 miles over approximately six years, the vehicle has averaged roughly 8,614 miles per annum. This usage rate is considered typical for a modern hatchback and suggests a balanced duty cycle, likely consisting of a mix of urban and motorway driving. There are no signs of excessive wear associated with high-mileage vehicles, nor are there indications of the mechanical stagnation often found in cars that have stood for prolonged periods. Given the absence of MOT advisories, the focus of a physical inspection should shift toward age-related wear and service history verification. You should examine the tyre treads and sidewalls for any signs of perishing or uneven wear, which could indicate a need for wheel alignment or the arrival of the end of the tyres natural lifespan. Check the brake discs for surface corrosion and ensure the calipers are not binding, as even well-maintained vehicles can develop minor pitting if not driven vigorously. The 12V battery health should also be verified to ensure it holds a sufficient charge. It is critical to verify the service book stamps to ensure that calendar-based maintenance has been adhered to, regardless of the mileage. Pay close attention to the oil change intervals and the condition of the engine oil and coolant, as fluid degradation occurs over time even with moderate usage. During the test drive, listen for any subtle knocks or clunks from the suspension bushes and coil springs, and ensure the gear transitions are smooth. A comprehensive check of the interior electronics and air conditioning system is also recommended to ensure all ancillary components are functioning as intended.