2015 Skoda Fabia 1.0L Petrol · SD65 FOV

Recurring exhaust system issues and emissions failures define the recent mechanical profile of this Skoda Fabia, with the most recent test on 10 November 2025 resulting in a pass with no defects. The vehicle has experienced a pattern of instability regarding its exhaust integrity and lambda sensor readings, having failed in April 2024 due to exhaust lambda readings falling outside specified limits. This issue persisted into the April 2025 test, where the vehicle failed again for the same emissions reading before being presented with an advisory for a minor leak in the front exhaust. While the latest result shows these specific issues have been addressed, the history indicates a period of intermittent failure in the exhaust and emissions control components. The recorded mileage of 63,670 miles over an eleven-year period reflects a relatively low annual usage rate of approximately 5,788 miles. This pattern of low mileage can mean that mechanical components such as suspension bushes, coil springs, and braking hardware have undergone fewer cycles of heavy load, but it also increases the possibility of components such as seals or exhaust gaskets becoming brittle or seizing due to infrequent thermal cycling. The mileage accumulation is consistent with a vehicle that has seen light, intermittent use rather than high-speed motorway transit or heavy urban stop-start driving. A prospective buyer should pay close attention to the exhaust system during a test drive to ensure the minor leak noted in April 2025 has been fully rectified. Listen for any rhythmic ticking, hissing, or increased engine note that might suggest a persistent leak from the exhaust manifold or front downpipe. Any noticeable change in engine idle smoothness or a hesitation in acceleration could be linked to the previous lambda reading failures, which relate to the oxygen sensor's ability to accurately monitor the air-fuel mixture. Beyond the exhaust system, the low annual mileage suggests that while wear on consumables like brake discs and pads may be lower than average, it is prudent to inspect the vehicle for any signs of fluid weeping or perished rubber components. On the test drive, pay attention to the responsiveness of the throttle and the stability of the idle to ensure the emissions system is operating within the correct parameters. Any unusual vibrations through the floorpan or a change in exhaust sound under load should be investigated as potential signs of remaining exhaust or mounting issues.