2023 Volkswagen T-ROC Life TSI 1.0L Petrol · WD72 OAE

Low annual mileage and a single, non-mechanical advisory characterize the roadworthiness profile of this Volkswagen T-Roc. The most recent inspection on 19 January 2026 resulted in a pass, with the only recorded issue being a nearside rear child seat preventing a full inspection of the adult seat belt. This represents a very clean testing history with no recorded failures or mechanical advisories regarding the vehicle's structural integrity, braking systems, or suspension components during its recorded MOT history. The vehicle has covered 17,722 miles over approximately three years, which equates to an average annual accumulation of roughly 5,907 miles. This usage pattern is significantly lower than the UK national average, suggesting the vehicle has been used primarily for short-distance trips or has spent considerable periods stationary. Mechanically, this lower mileage typically results in less wear on high-friction components such as brake discs, pads, and tyre treads, and less fatigue on suspension bushes and coil springs. However, it also means the engine and exhaust system have not been subjected to the regular high-temperature operating cycles associated with longer motorway journeys. Because the MOT record is devoid of mechanical defects, the primary focus for a prospective buyer should be on verifying that the low-mileage usage has not led to issues related to inactivity. While no specific mechanical advisories were issued, it is prudent to inspect the vehicle for any signs of fluid weeping from gaskets or seals, which can sometimes occur when a vehicle is driven infrequently. During a test drive, pay close attention to the smoothness of the engine idle and the responsiveness of the transmission to ensure that the drivetrain has remained healthy despite the light usage. Regarding the specific advisory noted in the January 2026 test, the nearside rear adult seat belt was not fully inspected due to a child seat being fitted. It is essential to remove any child restraints to physically inspect the entire length of the seat belt webbing for fraying, cuts, or heavy staining, and to ensure the retractor mechanism operates smoothly without snagging. Additionally, check that the buckle and tensioning system function correctly to ensure full compliance with safety standards, as this was the only item flagged during the most recent inspection.