2017 Bentley Flying Spur 4.0L Petrol · YXS 1

The Bentley Flying Spur’s latest MOT test on 2026-04-01 resulted in a clean pass, maintaining a consistent and positive maintenance trend over the past five years. The vehicle has not encountered any defects, advisories, or failures during its MOT assessments, indicating a stable roadworthiness profile with no recurring issues that would suggest underlying mechanical degradation or neglect. This consistency is particularly noteworthy given its age and the low annual mileage recorded, reinforcing the likelihood that the car has been well-maintained or operated under conditions that minimise wear. The absence of advisories—such as fluid leaks, excessive tyre wear, or structural concerns—also supports the impression of a well-kept vehicle, though the low mileage may mask some age-related wear that could become more apparent with increased use. The recorded mileage of 21,370 miles for a 2017 Flying Spur represents an unusually low annual usage rate of approximately 2,374 miles per year, which is significantly below the typical wear patterns expected for a luxury vehicle of this age. Such low mileage can be attributed to either light usage, long periods of stationary storage, or a preference for alternative transportation methods. However, this usage profile carries important implications for the vehicle’s condition. Extended periods of inactivity can lead to issues such as corrosion from standing fluids, particularly in the brake systems where moisture can accelerate rusting of discs and calipers, or in the suspension where components like coil springs and bushings may degrade more rapidly due to lack of movement. Additionally, long-term storage without fluid top-ups can result in degradation of hydraulic brake fluid, engine oil, and coolant, all of which may require replacement before they reach their service life. Given the clean MOT history and low recorded mileage, the prospective buyer should conduct a thorough physical inspection to address potential age-related and usage-specific concerns. First and foremost, the tyres should be examined for signs of sidewall perishing or cracking, which can weaken their structural integrity and compromise safety, especially on the Bentley’s high-performance handling characteristics. The vehicle’s battery should be checked for signs of corrosion on terminals, poor connections, or reduced cranking power, as a failing 12V battery can lead to persistent electrical issues or even a total failure under load. The brake system is critical; the buyer should inspect the discs for corrosion, warping, or binding, and the calipers for any signs of sticking or excessive heat discolouration, which could indicate hydraulic failure or mechanical binding. During a test drive, listen for unusual noises such as grinding from worn discs, squeaking from brake pads, or clunking from suspension components like bushes or struts. The suspension should be tested for alignment and wear, with particular attention to the front and rear coil springs, which may show signs of sagging or excessive compression. Check for uneven tyre wear patterns, which could signal misalignment, camber issues, or worn suspension components. The engine oil level and condition should be verified, with a focus on colour and viscosity, as well as any signs of contamination or sludge buildup, which could indicate prolonged oil degradation. The coolant system should be inspected for leaks or signs of overheating, and the exhaust emissions system should be checked for leaks or unusual noises, as these can impact both performance and compliance with emissions standards. Finally, the buyer should review any service records or maintenance logs to confirm that time-based servicing, such as the replacement of fluids (engine oil, brake fluid, coolant, and transmission fluid) and filters, has been conducted according to the manufacturer’s recommendations. Given the vehicle’s age, these fluids may have reached or exceeded their service life, necessitating replacement to prevent catastrophic failure or reduced performance. Additionally, a professional inspection by a qualified Bentley specialist could provide further reassurance, particularly for high-value components like the drivetrain, transmission, and electrical systems, which may not be covered in routine MOT checks.