2011 Volkswagen Polo 1.2L Petrol · YY60 UBN

The vehicle is currently roadworthy but the maintenance trend reveals a concerning lack of attention to recurring mechanical defects. While it passed the test in February 2026 at 91,497 miles, the tester identified new faults including a corroded offside rear brake pipe and play in the nearside front steering rack inner joint. This indicates that while the owner is addressing immediate issues to pass the MOT, they are failing to perform preventative maintenance on components that have appeared or persisted over multiple years. At 91,497 miles over 15 years, the Polo has covered an average of approximately 6,100 miles per year, which is consistent with low-use local commuting. The record shows steady usage between annual tests, with roughly 3,400 miles driven between February 2025 and February 2026. However, the low mileage has not protected the vehicle from age-related degradation of rubber components and metalwork, as evidenced by the persistent issues with suspension bushes and exhaust mounts despite the low odometer. A buyer must prioritize a thorough inspection of the steering system, as the steering rack inner joints have been flagged in nearly every test since at least 2023. The failure in February 2023 due to a split CV boot further suggests that drivetrain components are being neglected until they reach a point of failure. Additionally, the corroded offside rear brake pipe noted in the most recent test is a safety concern that requires immediate verification to ensure the corrosion has not progressed to a point that could lead to fluid loss. The history also shows a pattern of poor tyre wear, specifically the front inner edges reaching the legal limit in early 2023. This often points to alignment issues or worn suspension geometry that has not been properly corrected. Given the previous exhaust leaks and defective mounts noted in 2023, the buyer should also verify that the entire exhaust system has been properly replaced or secured rather than merely patched to satisfy the tester.