2016 Ford Focus 1.5L Diesel · FJ16 AAE

An unbroken sequence of clean test certificates forms the backbone of this Ford Focus history, demonstrating a reliable progression through annual statutory examinations that culminated in a pass on 25 February 2026 without a single advisory recorded. This unblemished recent trajectory mirrors a similar lack of defects noted during tests in 2022, 2024, and 2025, alongside earlier years stretching back to 2019, punctuated only by a single minor tyre edge wear advisory in February 2020. The cumulative data indicates a well-preserved structural and mechanical compliance record over seven consecutive years of testing, pointing to consistent attention to basic roadworthiness requirements prior to each annual inspection. With 75,614 miles recorded by the time of its early 2026 test at roughly ten years of age, the vehicle has accumulated an average of approximately 7,500 miles annually, representing a standard and predictable rate of British motoring usage. This steady accumulation avoids the accelerated wear associated with high-mileage fleet duties while equally circumventing the risks of prolonged inactivity or chronic standing that can cause seizure in braking components or degradation of rubber seals. Mechanically, this usage profile suggests that core assemblies such as the clutch, gearbox, and steering linkages have experienced normal operational cycles without the strain of severe urban congestion or heavy towing. Despite the absence of persistent technical defects in the official record, prospective buyers must still perform targeted checks during a physical inspection and test drive, focusing specifically on the front axle geometry where the 2020 tyre wear advisory originated. Listen carefully for any dull knocking or metallic clunks emanating from the front suspension when negotiating potholes, speed humps, or sharp turns, which would indicate worn anti-roll bar links, lower control arm bushes, or track rod ends. Additionally, inspect the inner and outer tread surfaces of all four tyres manually to ensure even wear patterns across the contact patch, verifying that wheel alignment remains properly calibrated. During the dynamic road test, pay close attention to the braking performance by applying firm pressure at moderate speeds to detect any steering pull, brake judder through the pedal, or sticking calipers that could compromise stopping efficiency. Check that the manual transmission engages smoothly across all ratios without slipping or hesitation under load, and verify that the steering centers correctly after cornering. While the statutory testing history confirms that the vehicle has repeatedly met minimum safety standards, a thorough inspection of the underbody for surface corrosion on the structural subframes and brake lines will ensure long-term durability matches the clean paper record.