2010 Hyundai Santa FE 2.2L Diesel · P333 ALS

A signature fault of this generation's CRDi diesels: worn injectors with excessive return flow, or a failing pump metering valve, drop the common rail below the pressure needed to start or keep running. A UK diagnostic case that ran through this forum thread saw a Santa Fe given a second-hand high-pressure pump, new metering valve, new regulator, rail sensor and even a used ECU before the real cause was traced - classic example of the expensive parts-swap merry-go-round workshops fall into. Symptoms are hot no-starts, starting on starter fluid then never restarting, and low-pressure codes such as P1181 hidden behind intermittent limp.

Fault-file analysis and Get Car Wise's MOT-based guide both flag the D4HB 2.2 CRDi (fitted from 2009) for variable-geometry turbo actuator sticking and EGR coking, driven by short-journey use and extended oil intervals. The vanes gum up, boost falls away, the car drops into limp and, if driven on, a seizing turbo can scatter debris that destroys the engine - both sources put failure in the 80,000-180,000 mile band. Cleaning the EGR and freeing the actuator is a couple of hundred pounds; a replacement VGT turbo fitted runs into four figures, which is more than most remaining examples are worth.

A serious safety defect affecting second-generation Santa Fes led to multiple DVSA recall campaigns (including R/2020/223). Moisture ingress into the Hydraulic Electronic Control Unit (HECU) causes an internal electrical short circuit across the printed circuit board. This leaves the ABS module continuously energised even after the engine and ignition are switched off, draining the 12V battery and creating an engine bay fire risk. Dealership remedy involves installing a dedicated power-supply relay in the engine bay fusebox to isolate the unit when the ignition is switched off.