2017 Audi TT S Line Tfsi Quattro S-A 2.0L Petrol · RO17 EXA

Consistent roadworthiness defines this vehicle, which has maintained an unblemished record throughout its six most recent annual inspections. Since the 2020 test, every assessment has resulted in a pass without a single advisory or failure recorded. This streak of clean MOT outcomes indicates that the vehicle has successfully met the required safety and environmental standards at each mandatory check, with no recurring mechanical issues or structural defects flagged by testers over the past five years, culminating in the most recent successful pass on 15 November 2025. Accumulating 54,076 miles over nine years results in an average annual usage of approximately 6,000 miles, a figure that aligns with typical expectations for a vehicle of this age. The testing frequency has remained consistent, ensuring that the car has been subjected to regular oversight without significant gaps in its history. While this moderate usage profile suggests the vehicle has not been subjected to extreme high-mileage wear, it is important to note that lower-mileage vehicles can sometimes experience accelerated degradation of rubber components or seals if they have been left stationary for extended periods between tests, though no such issues have been documented in the official history. Given the absence of recorded advisories, the primary focus during a test drive should be on the condition of high-wear items that are reaching the age where replacement is often required regardless of mileage. Pay close attention to the suspension system, specifically listening for any knocking or metallic clunking sounds when traversing uneven surfaces, which could indicate wear in the control arm bushes or drop links. Additionally, test the braking system for any signs of pedal judder or uneven deceleration, as the current discs and pads may be nearing the end of their service life given the vehicle's age and the increased likelihood of surface corrosion on the braking surfaces from intermittent use. The steering and drivetrain should also be evaluated for responsiveness and smoothness. During the test drive, ensure the steering remains centered without pulling to either side, and check for any vibrations through the steering wheel at motorway speeds, which could point to wheel balancing issues or uneven tyre wear. Since the vehicle has consistently passed emissions testing, monitor the exhaust for any unusual smoke or hesitation during acceleration, which would warrant a closer inspection of the engine management and induction systems. While the MOT history is clean, these physical checks are essential to confirm that the vehicle remains in a state of sound mechanical operation.