FORD FOCUS2010 · 1.6L Petrol

The 2010 Ford Focus presents a clean MOT history over the past two years, with no defects recorded in the most recent tests conducted on 2026-02-18 at 131,031 miles. Both the pass and fail entries for that date—an anomaly in the system—confirm the vehicle met all roadworthiness standards, including structural integrity, emissions, lighting, and critical mechanical components. The absence of advisories or minor faults in the December 2024 and December 2023 tests suggests consistent upkeep, though the duplicate pass/fail entries may indicate a clerical error rather than a mechanical issue. At this stage, the maintenance trend appears stable, with no signs of recurring problems or deteriorating conditions. The mileage accumulation of 8,189 miles per year aligns closely with the average for a 16-year-old vehicle, reflecting neither excessive wear nor neglect. The gap between the 2023 test (114,466 miles) and the 2024 test (126,074 miles) covers roughly 11,608 miles over 12 months, a steady pace that avoids the rapid degradation often seen in high-mileage annual runs. The most recent 4,957 miles since December 2024 were covered in just five months, which could imply slightly heavier recent use—but without faults, this does not necessarily signal mechanical stress. The sparse but consistent MOT record leaves little to infer about service intervals beyond basic compliance. Given the lack of recorded faults, a buyer should still verify key wear items in person, particularly those prone to silent failure in this model. Inspect the suspension components—such as coil springs, dampers, and bushings—for uneven wear or oil leaks, as these are common high-mileage issues even when not flagged in tests. Check the brake system thoroughly: binding calipers, uneven disc thickness, or seized hubs often escape MOT scrutiny unless severe. Exhaust emissions and fuel system integrity should also be confirmed, as older Focus models can develop subtle leaks or sensor drift. Finally, examine the underbody and wheel arches for corrosion, especially around the sills and rear subframe, as rust can compromise structural integrity without immediate MOT consequences.